Dial2Fast is supported by its audience. When you purchase through our links, we earn an affiliate commission from qualifying purchases

How To Fix LED Turn Signal Hyperflash Issue with Load Resistors

If you ever installed LED lights in your front and back turn signal of your vehicle, you will most likely notice an issue called hyperflash. This is caused by the fact that your flasher relay in your vehicle is designed to see a specific load on a regular filament light bulb. When you install LED lights, the load is much smaller and the flasher relay thinks the light bulb is burnt. The hyperflash is actually a feature to tell drivers that they need to replace the burnt light bulb.

To rectify this problem, I will show you how to install the 7440 load resistors for your Honda. The installation is very quick and easy. All you need to do is install the load resistor in line between the factory wiring harness and the LED light. This will fix any hyperflashing issue you may have. You can purchase the 7440 load resistors in the link below.

 

Liked it? Take a second to support Dial2Fast on Patreon!
Bookmark the permalink.

Comments are closed.